LVM Notes

I wanted to upgrade the disks in my Linux PVR to a 1TB pair and thus had to migrate from one existing disk (/dev/sda) to the new (/dev/sdb):

1. Add new physical disk to system

2. Partition disk to have a linux LVM partition – use flag 0x8e

# fdisk /dev/sdb

3. Add to LVM

# pvcreate /dev/sdb2

4. Add physical LVM volume to a LVM volume group (VolGroup00)

# vgextend /dev/VolGroup00 /dev/sdb2

2. Move all lvm volumes off old lvm disk

# vgdisplay -v (look for old physical volume name)

# pvmove /dev/olddisk      # will move all physical extents from olddisk to any available pv in the vg

3. Remove old disk from vg

# vgreduce /dev/olddisk

4. Remove old disk from LVM

# pvremove /dev/olddisk

RAID Notes
Debian RAID setup on my PVR:
/dev/md0  /boot
/dev/hda1
/dev/hdb1
/dev/md1  /
/dev/hda2
/dev/hdb2
/dev/md2  swap
/dev/hda3
/dev/hdb3
/dev/md3  /data
/dev/hda4
/dev/hdb4

Show detail of RAID set:
# mdadm –detail /dev/md0

Detach mirror member:
– first mark member as bad (unless is really is bad, in which case it’ll already be marked faulty):
# mdadm –set-faulty /dev/md0 /dev/hdb1
– now remove it from the RAID1 set
# mdadm –remove  /dev/md0 /dev/hdb1

To reattach member (after partitioning, or if it’s the same disk):
# mdadm   /dev/md0  –add  /dev/hdb1
– to watch the progress on the resync, look at /proc/mdstat
# cat /proc/mdstat

I think now (2010/01/24) the faulty syntax is:

mdadm /dev/md0 –fail /dev/sdb1

then

mdadm /dev/md0 –remove /dev/sdb1

Crypto Filesystem Notes

Linux (2.6) crypto filesystems are supported via a loopback device. Various ciphers can be specified.  This example, default AES cipher is used and the disk partition is /dev/sdb1 – which is just setup as a normal Linux (0x83) partition.

1. Load the crypto filesystem module

modprobe cryptoloop


2. Start the crypto device (I’ll insert initialization instructions here later)

Note – you don’t need losetup, if the parameters are specified in fstab and mount does the startup. When losetup runs, it will prompt for the passphrase used to encrypt the partition. Once the crypto driver has the correct key to allow on the fly encryption/decryption, then processes that use the partition see cleartext (such as mount).

losetup -e aes /dev/loop0 /dev/sdb1 || exit 1
mount /bu